A floor photo helps.
It does not finish the diagnosis.
One image can show coating residue, scratches, patches, shine, dust, edge problems, and uneven areas. It cannot confirm the full machine setup, concrete hardness, tool direction, or what happened in the previous pass.
That is why the right recommendation needs both photos and job details.
What a photo can show quickly
A clear photo can show whether the floor is still covered with coating.
It can show glue lines, old epoxy, mastic residue, patchy removal, deep scratches, cloudy polish, and edge problems.
It can also show whether the floor is being treated as a removal job, grinding job, transition job, or polishing job.
That is useful. It saves time.
What a photo cannot prove
A photo cannot prove concrete hardness.
It cannot prove whether the tool is correct for the machine.
It cannot prove rotation direction.
It cannot prove plate fitment.
It cannot prove whether the previous grit was skipped.
A photo gives clues. It does not replace fitment details.
If the floor still has coating
If the photo shows epoxy, glue, mastic, waterproofing, or thick coating residue, the first question is removal.
A resin pad is not the answer.
A fine metal bond tool is usually not the first answer either.
The job may need PCD and Coating Removal before grinding begins.
If the floor is open but rough
An open, rough floor usually means the job has moved past simple removal.
Now the question becomes scratch control.
The floor may need metal bond diamonds to grind, level, or prepare the surface for the next step.
For that stage, review Metal Bond Grinding Tools.
If the floor is scratched but already clean
This is where many jobs go wrong.
The floor looks clean, so the contractor wants to polish.
But the scratches are still there.
If the scratches are metal scratches, resin pads may not remove them cleanly.
A hybrid transition step may be needed before resin polishing.
For this stage, review Hybrid Pads.
If the floor is shiny but cloudy
A shiny floor with haze usually points backward in the workflow.
The problem may be an earlier scratch, skipped transition, dirty floor, wrong resin sequence, or uneven edge work.
Do not solve haze by jumping to a finer pad immediately.
Check the previous step first.
For final polishing tools, review Resin Polishing Pads.
Machine photos matter as much as floor photos
The floor photo shows the problem.
The machine photo shows what can actually be installed.
Send the grinder model.
Send the plate photo.
Send the back side of the current tool.
Send the tool face if it is worn or glazed.
Without those details, fitment becomes guesswork.
The best photo set
One wide floor photo shows the overall condition.
One close floor photo shows scratch and residue.
One edge photo shows whether borders are different from the open area.
One machine plate photo shows fitment.
One used tool photo shows what the current tool is doing.
That group of photos gives a much better starting point than one polished floor image.
The question behind the photo
Every floor photo needs a question.
Are you removing coating?
Are you opening hard concrete?
Are you preparing for coating?
Are you trying to remove metal scratches?
Are you polishing for clarity?
The tool choice changes with the answer.
What to send with the photo
Send the machine model.
Send the plate or holder system.
Send the current tool and grit.
Send whether the job is dry or wet.
Send the floor condition.
Send the target result.
Send the quantity and destination country.
If the photo does not show the machine system, confirm fitment before ordering.
Related Tools and Next Step
If the photo shows epoxy, glue, mastic, or coating residue, review PCD and Coating Removal.
If the floor needs grinding, leveling, or scratch control, review Metal Bond Grinding Tools.
If metal scratches need refinement before resin, review Hybrid Pads.
If the floor is ready for final polishing, review Resin Polishing Pads.
Send floor photos, machine plate photo, current tool photo, job step, and target result through Contact.