Overview

These double bar metal bond diamond grinding shoes are designed for CPS grinder style 3-hole trapezoid systems. They are suitable for concrete floor grinding, floor leveling, and surface preparation where stable cutting and consistent scratch patterns are needed.

The double bar segment layout is a practical choice for general grinding work, early-stage floor prep, and moving the floor toward finer grinding or polishing steps.

Best for

• Concrete floor grinding

• Floor leveling and surface preparation

• Opening cuts before finer grinding steps

• Scratch reduction on concrete floors

• CPS grinder compatible 3-hole trapezoid systems

Features

• 3-hole trapezoid mounting style

• Double bar metal bond segment design

• Designed for CPS grinder systems

• Suitable for concrete grinding and floor prep

• Good for opening cuts and general grinding work

• Can be used in wet or dry grinding, depending on jobsite conditions

Fitment Note

Designed for CPS grinder style 3-hole trapezoid holder systems. Please confirm your plate and holder style before ordering. If you are unsure, send us a photo of your current tool or plate for fitment confirmation.

FAQ

What is this tool mainly used for?

It is mainly used for concrete floor grinding, leveling, and surface preparation.

What is the advantage of the double bar design?

The double bar layout gives stable grinding contact and is widely used for general concrete grinding and scratch reduction.

Is it suitable for CPS grinders?

Yes, it is designed for CPS grinder style 3-hole trapezoid systems. Please confirm your holder style before ordering.

Can it remove coatings?

It can help remove thin surface residue or weak coatings. For heavy epoxy or thick glue removal, PCD tools are usually the better choice.

What should I use after this tool?

That depends on your floor condition and target finish. In many cases, the next step is a finer metal bond grit, then transitional pads or resin polishing pads if polishing is needed.